Mitsubishi Pajero 3 V60 PU Bushing Set

• Mitsubishi

• Pajero 3 V60

Renew the coordinated suspension bushes on your Mitsubishi Pajero III V60/V70 and reduce play that can accumulate across its independent front and rear suspension. Multiple control-arm bushes influence wheel position under braking, cornering and changing loads.

This orange 75 Shore A polyurethane kit covers the listed front and rear control-arm positions together with both anti-roll bars.

Key details

• Fits: Mitsubishi Pajero III V60/V70, 05/2000–2006
• Position: Front and rear control arms and anti-roll bars
• Material: Polyurethane
• Hardness: 75 Shore A
• Colour: Orange

More stable independent-suspension geometry

Polyurethane deforms less than aged rubber under braking and lateral forces and can help each control arm retain its intended position more consistently. The final result also depends on joints, wheel bearings, dampers and the remaining suspension components.

Kit contents

• Front upper control arms, inner mounts: 4 PU bushes and 4 metal sleeves
• Front lower control arms, front and rear inner mounts: 4 PU bushes and 4 metal sleeves
• Rear control arms, axle-side mounts: 2 PU bushes and 2 metal sleeves
• Additional rear control-arm mounts: 6 PU bushes and 6 metal sleeves
• Further rear mounting positions: 2 PU bushes and 2 metal sleeves
• Rear frame-side mounts: 2 PU bushes and 2 metal sleeves
• Front anti-roll bar: 2 PU bushes
• Rear anti-roll bar: 2 PU bushes

Installation note

Document every position before removal. Inspect all arms and mounts for corrosion or deformation, remove the old bushes completely and clean the contact surfaces. A professional wheel alignment is recommended after installation.